1/100 Crossbone X1 MG WIP

[Quinn Cheng]

Another model kit.
With the work I done so far, I can say its the best work I did ever. I just hope I can continue that to finish it.


Compared to a snapped kit I was ashamed of....

 :countonme:
Anyways while i was assembling kit yesterday, A disaster happened!!! I put the part in the wrong direction and it got stuck. Then i couldn't pull it out... Being the noob I was I was at first in total shock then I decided to do some surgery... So I cut the part into two halfs and then it finally snugged off. Then I was faced on how to fix it, so I took my luck and applied some Milliput. The results... i have mixed feelings of.




Disappointment

So what do I do? (First time something like this has ever happened) I tried fixing it lol...
Ok all the work I have done today.






Heres the fixed version! I think it ended up pretty good...




I got my waterslides for the Crossbone and apparently they come with Crossbone X1 Skullheart decals. To me they look pretty cool but I just wanna know if I should apply them and if I do where would be a good spot?


NEED FEEDBACK FOR THIS!!!

[Quinn Cheng]

Ok so I applied some water decals today. But their very noticeable for some odd reason...